Bmw Keymaker Prog

BMW KEYMAKER PROG

BMW KEYMAKER Programme is for keyprogramming

(PCF transponders 7930,7931,7935 This programme is very

simple in using it and does not require additional equipment to

work with EWS 2,3,3+.Programme and adaptor BMW KEYMAKER  

are not used for  68HC11EA9 processor which has LOCK BIT

on it.If a processor has LOCK BIT on it the programme will warn

about it.Operating EWS

Examine EWS carefully to find processor 68HC11EA9(mask 2D47J,1D47J,0D46J).Cut PIN 20 from the processor on

EWS motherboard as it is shown in the picture.

Choose quartz type 614000(EWS 2) in the programme or

8000000(EWS 3,3+). Then connect the processor 68HC11EA9

using the connector following this picture.(WARNING!!!Adaptor

BMW KEYMAKER should be cut from power supply during this!!!)

Connect explanation

Black to processor’s Pin1

Green to processor’s Pin2

White to processor’s Pin3

Blue to processor’s Pin17

Red to processor’s Pin20

Purple to processor’s Pin21

Brown to processor’s Pin22

Orange to processor’s Pin26

After you connect the processor, connect power supply to BMW

KEYMAKER.In the programme press button READ EE EWS.

After reading the processor you will see dump in screen. Replace

pin 20 after reading processor is over.

Write key number in  the window from 0 to 9(alltogether there are

10 keys)which you want to programme.

Insert key or transponder into the keyhole of the programmerand

press PROGRAMME KEY button.

 Key or transponder will be programmed in 20 seconds.Repeat all

the operations for the other key numbers